insulating rod

What must be Paid Attention to in the Use of Insulating Rods?

The things that should be noted: 1. Before used, the surface of the insulating rod should be wiped clean with a dry cloth to keep the surface clean and dry; meanwhile, collision should be avoided so as not to damage the insulating layer of the insu……

The things that should be noted:

1. Before used, the surface of the insulating rod should be wiped clean with a dry cloth to keep the surface clean and dry; meanwhile, collision should be avoided so as not to damage the insulating layer of the insulating rod surface;

2. Wear insulating gloves and insulating boots when operating;

3. The holding part of the hand should not exceed the isolation ring during operation;

4. The model and specification of the insulation rod shall be in accordance with the regulations and shall never be used for any purpose;

5. There must be a rainproof umbrella cover on the insulating rod to keep it dry when it is used in rain, snow or wet weather;

6. Insulating rod shall be subject to regular insulation test.

epoxy glass cloth rodPHENOLIC COTTON CLOTH ROD

Storage methods:

1. An insulating rod is usually composed of three sections. When storing or carrying, we should decompose each part, and put it in a special tool bag with the exposed screw thread upwards to prevent the surface abration or damage of the screw.

2. When storing, choose a well-ventilated, clean and dry place, and suspend it on the brake lever, managed by the special person. Insulation board should not be exposed to the wall to avoid moisture.

3. Once the surface of the insulation rod is damaged or dampened, it should be handled and dried in time. The surface damage of the rod should not be wound with wire or plastic tape. When drying, it is best to choose the natural drying method of sunlight, rather than be roasted with fire. After treatment and drying, the brake lever must be tested and qualified before reusing.

4. An ac withstand test must be conducted annually. The unqualified insulating rod should be scrapped immediately and destroyed, and the standard should not be reduced. It should not be put together with the qualified insulation rod.

 

Leave a message

Your email address will not be published. Required fields are marked *

Goto Top
ztelec